info@ndtsbd.com
+88 01782777700
Radiography Testing Service:

Radiography is the most popular and commonly known non-destructive test method. Radiography can be used to get permanent image of surface and sub-surface discontinuities. The similar discontinuities can be radiographed again after a period of service life and the radiographs can be compared to measure the change in the size and shape of the discontinuity. There are many applications of radiography in engineering applications.



Some of the common uses are detection of surface and subsurface features of interest in welded joint, forgings, castings, corrosion mapping, wall thickness measurement, discovery of blockages inside sealed equipment.

Recently we encourage people about Ultrasonic imaging test, replace of RT or parallel use of RT. Phased Array Ultrasound is same like medical ultrasound. Ultrasonic Phased Array Imaging technique is document bases; past it was impossible, application is very fast, no radiation safety issue and inspects cost also cheaper then RT. If you need any RT test, please consult with us, we will check code and standard and propose you suitable inspection method.

Radiography setup is following

1. X-Ray Generator
2. X-Ray Generator for Crawler
3. X-Ray Control Unit
4. Gamma-Projector
5. Computed Radiography Scanner
6. Radiation Survey Meter
7. Densitometer
8. X-Ray Film
9. RT Accessories


Tools:

We Use X-Ray Generator capacity: 180kV Made in iCM, Belgium

Inspector:
We have RT Level-II skill inspector for execute our RT service.